195 documents in this book for reference only, not intended for design. not guaranteed for accuracy. genuine aircraft hardware co. all original text, tables, and drawings are copyright 1994-2006 reproduction by permission only. MS35489 grommets, synthetic and silicone rubber, hot - oil and coolant resistant a a e c e f g split as shown when required j notes: ?procurement specification: mil-g-3036 ?supersedes: ms35490 and an931 ?this information from military standard MS35489 page 1 of 3, revised feb. 17, 1989, some det ails ma y have been omitted for clarity. t able i. dash numbers and dimensions continued... kits available
genuine aircraft hardware co. all original text, tables, and drawings are copyright 1994-2006 reproduction by permission only. 196 documents in this book for reference only, not intended for design. not guaranteed for accuracy . MS35489 grommets, synthetic and silicone rubber, hot - oil and coolant resistant requirements: 1. ma terial: rubber, synthetic, composition a, in accordance with procurement document, rubber, silicone, composition b, in accordance with procurement document. 2. color: black (composition a). red or orange (composition b). 3. p ar t number: the p art number shall consist of the basic ms number followed by a dash number from table i, plus a material code letter ?or silicone rubber, no code letter for synthetic rubber. example: MS35489 -14 x ma terial code ? -ilicone rubber no code - synthetic rubber dash number basic ms number MS35489-14x indicates - grommet, silicone rubber, hot-oil and coolant resistant; groove width .062; hole diameter .500; groove diameter .812; outside diameter 1.062; thickness .312. 4. t olerance : tolerances shall be ?.031 inch for thickness (f) and outside diameter (?a); ?.016 inch for all other dimensions. notes: 1. all dimensions are in inches unless otherwise specified. 2. supersession: replacement part number relationships shall be in accordance with table ii. cancelled ms35490 grommets may be used until existing stocks are depleted. do not use ms35490 grommets to replace MS35489 or an931 grommets. an931 grommets and superseding MS35489 grommets are universall y , functionally and dimensionally interchangeable. 3. in the event of a conflict between the text of this standard and the references cited herein, the text of this standard shall take precedence. 4. referenced government (or non government) documents of the issue listed in that issue of the department of defense index of specifications and standards (dodiss) specified in the solicitation form a p ar t of this st andard t o the extent specified herein. 5. grommets previously procured with a split (suffix ?are no longer procured or stocked by services. for replacement use solid grommets, and split at assembly. additional notes: ? procurement specification: mil-g-3036 ? supersedes: ms35490 and an931 ? this information from military standard MS35489 page 2 of 3, revised february 17, 1989, some details may have been omitted for clarity. continued... continued...
197 documents in this book for reference only, not intended for design. not guaranteed for accuracy. genuine aircraft hardware co. all original text, tables, and drawings are copyright 1994-2006 reproduction by permission only. notes: ? procurement specifica tion: mil-g-3036 ? supersedes: ms35490 and an931 ? this informa tion from milit ar y st andard MS35489 p age 3 of 3, revised februar y 17, 1969, some det ails ma y ha ve been omitted for clarity . MS35489 grommets, synthetic and silicone rubber , hot - oil and coolant resistant * MS35489 solid grommets should be split a t assembl y when necessar y for replacement of ms35490 split grommets. continued...
|
